3 Maintenance
68
Maintenance
3
8
Hold the handle on the top of the cartridge,
and insert the cartridge in gently until it stops.
Note • Be sure it is slid all the way into the machine.
9
Pull out the cartridge tape straight toward you
and horizontally to prevent it from tearing.
Important •Be sure to pull out the tape straight and
horizontally. If it is pulled out upward, it may
be torn before it is completely out of the
cartridge.
10
Push the drum cartridge again so that it is
correctly placed.
11
Close the Cover A tightly.
12
Close the Tray 5 (Bypass).
13
Close the front cover.
Note • If the front cover is not completely closed, a message will appear and the machine will remain
paused.
Replacing Staple Cartridge (for Finisher-B1)
When the Finisher-B1 (optional) is installed and the staple cartridge needs to be replaced, a
message appears on the touch screen. When this message appears, load a new staple case
into the staple cartridge.
Important •The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
To Next Page
Loading...
Need help?
General
