Replacing Consumables
75
Maintenance
3
Emptying the Hole Punch Waste Container (for Finisher-B1)
When the Finisher-B1 (optional) is installed and the hole punch waste container becomes
full, a message appears on the touch screen. When the message appears, empty the hole
punch waste container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container. Not
doing so will cause the container to fill up before the message telling you to empty the
container appears again, and this can cause machine malfunction.
Important • Empty the hole punch waste container when the machine is on. If you empty the container while the
machine is off, the machine does not recognize that the container has been emptied.
• Empty the hole punch waste container after the message appears. Otherwise, the machine cannot
recognize the correct remaining amount of the punch scraps.
• When the machine is in Power Saver mode, exit Power Saver mode by pressing the <Power Saver>
button and the <Machine Status> button on the control panel before you empty the punch waste
container.
• Before emptying the punch waste container, press the <Machine Status> button and check the
current status for the punch waste container even when the control panel is lit.
1
Make sure that the machine is not operating,
lift the top transport cover, and then open the
front transport cover of the finisher.
2
Pull out the hole punch waste container.
3
Empty the container.
1
2
To Next Page
Loading...
Need help?
General
