7 Printer Environment Settings
306
Printer Environment Settings
7
Installation When Using Parallel Port
This section describes how to install the machine using a parallel interface.
The following shows the reference section for each procedure.
Step 1 Preparations..................................................................................................................................................................... 306
Step 2 Configuration on the Machine .................................................................................................................................... 306
Step 3 Configuration on the Computer.................................................................................................................................. 307
CentreWare Internet Services Setting Items ........................................................................................................................ 307
Step 1 Preparations
The following items are required to connect the machine to a computer via a parallel
interface.
z
The Parallel Port Kit (optional)
z
Parallel interface cable
z
Meida (Software/Product Manual) provided with the machine
Step 2 Configuration on the Machine
The following describes the configuration procedures to use a parallel interface on the
machine.
Note • You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.299).
1
Connect a parallel interface cable to the parallel interface connector on the machine.
2
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the Services Home screen.
3
Enable the parallel port on the machine.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [Parallel], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
4
Configure the following settings if required.
z
Print Mode
Configure the printer language on the machine to that of the received data.
To Next Page
Loading...
