3 Maintenance
72
Maintenance
3
Replacing Booklet Staple Cartridge (for Booklet Maker Unit for Finisher-B1)
When the Booklet Maker Unit for Finisher-B1 (optional) is installed and the staple cartridge
needs to be replaced, a message appears on the touch screen. When this message appears,
load a new staple case into the staple cartridge.
Important •The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and open the finisher side cover.
2
Hold the tabs on both sides of the staple
cartridge and pull the cartridge out of the
finisher.
3
Hold the tabs on both sides of a new staple
cartridge, and insert it into the original position
until it clicks.
4
Repeat steps 2 and 3 to replace the other staple cartridge.
5
Close the finisher side cover.
Note • If the finisher side cover is not completely closed, a message will appear and the machine will
remain paused.
Replacing Booklet Staple Cartridge (for C3 Finisher with Booklet Maker)
When the C3 Finisher with Booklet Maker (optional) is installed and the booklet staple
cartridges need to be replaced, a message appears on the touch screen. When this message
appears, replace the booklet staple cartridges with new ones.
Message Solution
The Booklet Staple cartridge [R2] is running out
of staples. Please order a Booklet Staple
Cartridge [R2].
Prepare new staples.
Note • Staples cannot be replaced yet.
To Next Page
Loading...
Need help?
General
