5 Tools
192
Tools
5
îš„ Server Name/IP Address
Enter a server name or IP address with up to 128 characters, and then select [Save].
îš„ Port Number
Enter a port number from 1 to 65535.
The default value is 110.
Important •Do not use the numbers assigned to the other ports.
îš„ Polling Interval
Set the interval for checking the e-mail on the POP3 server from 1 to 120 minutes in 1
minute increments.
îš„ Login Name
Enter the name to login to the POP3 server with up to 64 characters.
îš„ Password
Enter a password for the POP3 server with up to 64 characters.
Enter the same password in [New Password] and [Retype Password] using the numeric
keypad displayed by selecting [Keyboard]. If you do not set the password, leave the text
boxes blank and select [Save].
îš„ POP Password Encryption
Select [On (APOP)] to encrypt the password.
SMTP Server Settings
Set the SMTP server. In [SMTP Server Settings], you can set the following items:
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
îš„ SMTP Server Name/IP Address
Enter a server name or IP address, and then select [Save]. Up to 128 characters are allowed.
îš„ SMTP Server Port Number
Enter a port number in the range from 1 to 65535.
The default value is 25.
Important •Do not use the numbers assigned to the other ports.
îš„ E-mail Send Authentication
Select one from [Off], [POP before SMTP], or [SMTP AUTH].
Note • If [POP before SMTP] is selected, the POP3 settings must be set.
• AUTH GSSAPI (only for Kerberos), AUTH NTLMv2, AUTH NTLMv1, AUTH PLAIN, AUTH-LOGIN, or
AUTH CRAM-MD5 can be used as an authentication method.
îš„ Login Credentials for E-mail Send
Select the login user name when sending e-mails from [Remotely Authenticated User] and
[System]. When [Remotely Authenticated User] is selected and if the machine tries
authenticating the remote server before a job startup, the machine performs verification at
the time of transmission with the remotely authenticated user name and password. You can
also select the post-failure behavior of the machine from [Cancel E-mail Send] and [Relogin
To Next Page
Loading...
Need help?
General
