Connectivity & Network Setup
201
Tools
5
- When [SHA-256] is selected: DocuWorks 8.0 or later
XPS Signature
Select the setting for XPS Signature from [Do not add signature], [Always add invisible
signature], or [Select during send].
IPsec
Note • This item is not displayed when Secondary Ethernet (optional) is installed on the machine.
IPsec Settings
Configure the IPsec settings to use encryption or signature option on the transmission of e-
mail or fax.
Note • For [IKE Authentication Method], [Preshared Key], [DH Group], and [PFS Settings], consult your
network administrator.
z
IKE Authentication Method
Set the IKE authentication method. Select from [Authenticate by Preshared Key] or
[Authenticate by Digital Signature].
z
Preshared Key
Enter a preshared key. This setting is valid when [IKE Authentication Method] is set to
[Authenticate by Preshared Key].
z
Device Certificate
Select a certificate for IPsec communications.
Select a certificate when [IKE Authentication Method] is set to [Authenticate by Digital
Signature]. A self-signed certificate created by CentreWare Internet Services cannot be
used.
For more information on a certificate, refer to "Types of Certificate" (P.370).
z
IPsec Communication
Select whether or not to enable IPsec communications.
z
IKE SA Life Time
Specify IKE SA lifetime from 5 to 28800 minutes in 1 minute increments.
Note • The value must be greater than the value set in [IPsec SA Life Time].
z
IPsec SA Life Time
Specify IPsec SA lifetime from 300 to 172800 seconds in 1 second increments.
Note • The value must be smaller than the value set in [IKE SA Life Time].
z
DH Group
Set DH group. Select from [G1] or [G2].
z
PFS Settings
Select whether or not to enable PFS.
z
Destination IPv4 Address
Set the IPv4 address of the destination.
When entering an IP address, enter the address in the format "xxx.xxx.xxx.xxx", where
"xxx" is a numeric value from 0 to 255.
z
Destination IPv6 Address
Set the IPv6 address of the destination.
To Next Page
Loading...
