Error Code
467
Problem Solving
15
016-706
[Cause] The hard disk space is insufficient because the number of Secure Print users exceeded
the maximum limit.
[Remedy] Delete unnecessary files from the machine, and delete unnecessary Secure Print users.
For more information on deleting users for Secure Print files, refer to "11 Job Status" > "Printing and Deleting Stored
Jobs", and on folders, refer to "6 Send from Folder" > "Checking/Operating Files in a Folder" in the User Guide.
016-707
[Cause] Unable to print with the Sample Set feature because the hard disk is not installed.
[Remedy] To use the Sample Set feature, the hard disk must be installed. Contact our Customer
Support Center.
016-708
[Cause] Unable to annotate because of insufficient hard disk space.
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
016-709
[Cause] An error occurred during print processing.
[Remedy] Contact our Customer Support Center.
016-710
[Cause] Unable to register the Delayed Print document because the hard disk is not installed.
[Remedy] To use the Delayed Print feature, the hard disk must be installed.
016-711
[Cause] The upper limit for the e-mail size has been exceeded.
[Remedy] Take one of the following measures, and then try sending the mail again.
z
Reduce the number of pages of the document.
z
Lower the resolution with [Resolution].
z
Reduce the magnification with [Reduce/Enlarge].
z
Ask your system administrator to increase the value set for [Maximum Total Data
Size].
z
For color scanning, set [MRC High Compression] to [On] under [File Format].
016-712
[Cause] Unable to process the document because the specified scan area is too small.
[Remedy] Increase the resolution or scan area.
016-713
[Cause] The passcode entered does not match the passcode set on the folder.
[Remedy] Enter the correct passcode.
016-714
[Cause] The specified folder does not exist.
[Remedy] Create a new folder or specify an existing folder.
016-715
[Cause] The machine failed to access the ESCP form because the password of the ESCP form
does not match.
[Remedy] Enter the correct password of the ESCP form.
016-716
[Cause] Unable to spool TIFF file because of insufficient hard disk space.
[Remedy] Delete unnecessary files and users from the machine, or install the hard disk. For
information on installing the hard disk, contact our Customer Support Center.
Refer to "11 Job Status" > "Printing and Deleting Stored Jobs" in the User Guide.
016-717
[Cause] Unable to create a Transmission Report - Job Undelivered or a Transmission Report
because the transmission result information required for creating the report is not
stored in the machine's memory.
[Remedy] Take one of the following measures:
z
Execute the jobs for large size Internet fax documents (about 2GB) by splitting each
document to minimize memory or HDD usage.
z
If many scan or Internet fax documents are being processed, wait until the jobs are
completed to execute a new job.
z
After completing the job that you want to confirm in a report, do not execute 200 or
more jobs before printing the report.
Error Code Cause and Remedy
To Next Page
Loading...
Need help?
General
