36 Printer Connection and Software Installation
• WPS-PBC (WPS Button)
You can start WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) by pressing the (WPS) button.
NOTE:
• WPS-PBC is available only when the wireless LAN access point (Registrar) or router supports WPS-PBC.
• Before starting WPS-PBC with the (WPS) button, confirm the position of the WPS button (button name may vary) on the
wireless LAN access point (Registrar) or router. For information about the WPS operation on the wireless LAN access point
(Registrar) or router, refer to the manual supplied with the product.
• The (Wi-Fi) LED lights up or blinks to indicate the printer's wireless connection status. For more information, see "Status
of Wi-Fi LED" on page 19.
If a problem occurs or error messages are displayed on the LCD panel, see "Wireless Problems" on page 155.
1 Press and hold the (WPS) button on the printer for three seconds.
Confirm that the (Wi-Fi) LED starts to blink slowly and WiFi-WPS linking Timeout:[XXX] appears on
the LCD panel.
2 Start the WPS operation on the wireless LAN access point (Registrar) or router within two minutes.
When WPS is successful, the (Wi-Fi) LED lights up. The wireless connection is established and setup for
wireless LAN is complete.
• WPS-PBC (Operator Panel Menu)
You can start WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) from the operator panel.
NOTE:
• WPS-PBC is available only when the wireless LAN access point (Registrar) or router supports WPS-PBC.
• Before starting WPS-PBC, confirm the position of the WPS button (button name may vary) on the wireless LAN access point
(Registrar) or router. For information about the WPS operation on the wireless LAN access point (Registrar) or router, refer to
the manual supplied with the product.
• The (Wi-Fi) LED lights up or blinks to indicate the printer's wireless connection status. For more information, see "Status
of Wi-Fi LED" on page 19.
If a problem occurs or error messages are displayed on the LCD panel, see "Wireless Problems" on page 155.
1 Press the (Menu) button.
2 Select Admin Menu, and then press the button.
3 Select Network, and then press the button.
4 Select WPS Setup, and then press the button.
5 Select PushButtonControl, and then press the button.
6 Select Start, and then press the button.
7 Confirm that WiFi-WPS linking Timeout:[XXX] appears, start the WPS-PBC on the wireless LAN
access point (Registrar) or router within two minutes.
When WPS is successful, the (Wi-Fi) LED lights up. The wireless connection is established and setup for
wireless LAN is complete.
To Next Page
Loading...
Need help?
General
