Fuji Xerox DocuPrint CP475 AP User Manual

Emulation
287
Print control 51
(Blank sheet
output)
Sets whether to print blank pages if included in the document.
[0](Default): Off
[1]: On
Note

Even when [Off] is selected, blank pages are printed if they are spaces created with
user-defined characters or images in white color.

When [Off] is selected for this feature and 2 Up or 2 sided printing is specified,
blank pages are not printed.
52
(Character
print area)
Extends the position of the right margin.
[0](Default): Standard
[1]: Extended
Important

Changing the character print area from [Extended] to [Standard] restores the left
and right margins to the default values.

When the position of the right margin is set here, that position becomes the right
edge of the character print area.
53
(Image
enhancement)
Image Enhancement smoothens the border between black and white,
reducing rough edges, and thus seemingly increasing the resolution.
[0]: Off
[1](Default): On
ESCP switch 55
(Text quality)
Sets the Text Quality mode to high quality or draft.
[0](Default): High Quality
[1]: Draft
Important

Since the default value is selected for the [Text Quality], [Reduced Characters],
[Character Code Table], [Page Length], and [1-inch Perforation Skip] features, their
settings will not be affected when an extended command is received.
Note

Changing settings does not change actual printing quality.

This setting affects the Text Quality selection commands. For more information
on the Text Quality selection commands, contact our Customer Support Center.
56
(Reduced
characters)
Reduces the size of single-byte alphanumeric characters when printing. Sets
whether to reduce their sizes or to print them at a scale of 100%.
[0](Default): Off
[1]: On
58
(Page length)
Sets the length of a page (printable area) to 11 inches or 12 inches.
[0](Default): 11 inches
[1]: 12 inches
59
(1-Inch
perforation
skip)
Sets whether or not to leave a 1-inch space between pages.
[0](Default): Off
[1]: On
Important

This is effective only when CSF under [Paper Position] is set to [Off].
60
(Paper feed
position)
Sets the position to start printing at 8.5 mm or 22 mm below the top edge of
paper.
[0](Default): 8.5 mm
[1]: 22 mm
61
(CR feature)
Sets the action to be executed when a CR command is received.
[0](Default): Carriage return
[1]: Carriage return and linefeed
Setting Item Item Number Value

Fuji Xerox DocuPrint CP475 AP Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CP475 AP
Category	Printer
Language	English