Fujitsu AOYG18LBCA - Page 81

- 75 -
CASSETTE TYPE AUXG18-54LRLB
3. When the [Yes] on the verification screen is touched, a message screen is displayed.
4. When the [Close] on the message screen is touched, the display returns to the “R.C. Address
Setting” screen. Turn on the power again.
NOTES:
• Indoor unit remote controller address setting is necessary.
• Set the remote controller address of indoor units connected by the same remote controller cable
within a range of 1 to 9 and A (10) to F(15) so that there is no duplication. (Do not set to "0".)
• The address of remote controller is set within a range of 1 to 32, but set it so that it does not dupli-
cate the remote controller address of an indoor unit connected by the same remote controller
cable.
 How to reset the manual address setting number
1. Touch the [Address Reset] on the “R.C. Address Setting” screen.
2. A verification screen is displayed. When the [Yes] is touched, a verification screen is
displayed.
3. When the [Close] on the message screen is touched, the display returns to the “R.C. Address
Setting” screen. Turn on the power again.
No Yes
Manual Addressing
Manual address setting will be started. OK?
Setting is reflected after the power is
turned on again.
Manual Addressing
Close
[001–05]
R.C. Address Setting
Current Address
Back
Manual Addressing
Address Reset
No Yes
R.C. Address Setting
The address will be returned to factory
setting. OK?
Setting is reflected after the power is
turned on again.
R.C. Address Setting
Close