Fujitsu AOYG18LBCA - Wired Remote Controller (Touch Panel); 12-1.Remote Controller Address Setting

- 74 -
CASSETTE TYPE AUXG18-54LRLB
12. Wired remote controller (Touch panel)
12-1. Remote controller address setting
 How to confirm the remote controller address
NOTE: The address of this remote controller is set automatically. Do not change the indoor unit
remote controller address from the factory setting "0". (Verify that the address is "0".)
1. When the [RC Address Setting] on the “Maintenance” screen is touched, the “Installer Pass-
word Verification” screen is displayed.
2. Enter the installer password, and touch the [OK]. “R.C. Address Setting” screen is displayed.
The address of this unit is displayed on the “R.C. Address Setting” screen.
3. When the [Back] is touched, the display returns to the “Maintenance” screen.
 How to set the remote controller address manually
NOTE: Perform manual address setting only when setting the address with an arbitrary number.
Indoor unit remote controller address setting is necessary.
1. Touch the [Manual Addressing] on the “R.C. Address Setting” screen.
2. “Manual Addressing” screen is displayed. Set the address with [▲] or [▼]. When the [OK] is
touched, a verification screen is displayed.
Previous
Page
Back
Next
Page
Page 2/ 3 Maintenance
Test Run
R.C. Address
Setting
Function Setting
I.U. Address
Setting
[001–01]
R.C. Address Setting
Current Address
Back
Manual Addressing
Address Reset
R.C. address
(Unit number)
When the address
is set manually, this
mark is displayed.
[001–01]
R.C. Address Setting
Current Address
Back
Manual Addressing
Address Reset
01001
Manual Addressing
Cancel OK
System Unit