Operation
Changing the monitor settings
When putting the monitor into operation for the first time, the scree n d isplay should
be optimally adapt ed to the display adapter used.
Changing the monitor setti
ngs with the bu ttons
of the co n trol panel
The but tons of the control panel have two fu nctions. Whe n the OS D
menu is active, the current meaning of the bu ttons is shown directly
over the buttons on the edge of the screen.
The display over the button s varies depending on the sub-menu cho sen.
With the OSD menu not activated, you can make the following settings directly.
Call up OSD menu
Activate/deactivate ECO operating mode
Select input signal (digital/analog)
Adjust volume
Adjust brightness
Perform auto-adjustment of the monitor with analog input
ON/OFF switch with power indicator
Select OSD language
After the first switch on and after the monitor has been reset to the factory settings,
the selection screen for the language appears:
► Press the
ECO
/ butt o n or the
INPUT
/ button to select the desired language.
► Press the
MENU
/ buttontoconfirm or the
AUTO
/ button t o cancel.
After s electing the OSD language for the first time, you can change
it at any time in the OSD.
Fujitsu 21
To Next Page
Loading...
Need help?
General