Troubleshooting
Troubleshooting
Should an error occur, first check the following points. If the distortion is still not eliminated,
the monitor should, if possible, be c hecked on another compute r.
If you cannot s olve the problem, please co ntact our Service Desk.
Having this problem? Check th e following points:
No screen display
Power indicator is lit
► Check whether the computer is switched on.
► Check whether the data ca
ble for the
monitor is c orrectly scr
ewed into the monitor
port on the computer.
► Press any key on the compute r keyboard.
The compute r may be in p ower saving
mode.
► Alter the brightnes
s and/or contrast until you
get a picture.
Message: No Signal
► Check whether the data cable for the
monitor is c orrectly screwed into the monitor
port on the computer.
► Check whether the computer is switched on.
Message: Frequency out of range:
##kHz/##Hz
Please change the display mode
to 1920 x 1200 with 60 Hz
The i nput signal (horizontal frequency and
refresh rate) at the displayed input does not
correspond to the technical data for the monitor.
► Reboot the system after connecting to the
monitor. The VG A interface does not support
"Hot Plugging".
► Adjust th e video frequency range using the
computer software (see documentation for
the computer or display adapter).
► Set a different scre en resolution using the
computer software (see documentation for
the computer or display adapter).
42 Fujitsu
To Next Page
Loading...
