Trou blesh ooting
Troubleshooting
Should an error occur, first check the following points. If the distortion is still not eliminated,
the monitor should, if possible, be checked on another computer.
If you cannot solve the problem, please contact our Service Desk.
Having this problem? Check the follow ing points:
No screen display
Power indicator does not light up
► Check w hether the power cable on the
monitor is connected c orrectly.
► Check whether the comput
er is switched on.
No screen display
Powerindicatorislit
► Check whether the computer is switched on.
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Press any key on the computer keyboard.
The computer may be in power saving
mode.
► Alter the brightness and/ or contra st un til you
get a picture.
Message: No Signal
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Check whether the computer is switched on.
Message: Frequency out of range:
##kHz/##Hz
Please change the display mode to
1920 x 1080 with 60 Hz
The input sign
al (horizontal frequency and
refresh r ate
) a t the displayed input does not
correspond t
o the technical data for the monitor.
► Adjust the v
ideo frequency range using the
computer so
ftware (see documentation for
the compute
r o r display adapter).
► Set a different screen resolution using the
computer software (see documentation for
the computer o r display adapter).
Picture position not correct
The monitor recognises an undefined mode (see
chapter "
Technical specification", Page 3 2).
► Tou ch t h e
AUTO
sensor to cond uct
auto-adjustment of the screen.
Picture is shaking
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Tou ch t h e
AUTO
sensor to cond uct
auto-adjustment of the screen.
Picture is wrongly adjusted
► Run
the Fac tory Recall function in the OSD
men
u.
The Auto Processing message appears.
Fujitsu 29
To Next Page
Loading...
Need help?
General