To Next Page

To Previous Page

Important notes Installation and operation precautions

U41858-J-Z126-2-76 21

Dokuschablonen 19x24 Version 7.4us für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010

12. April 2017 Stand 18:58.58 Pfad: P:\FTS-BS\Server\SE-Server\SE-Doku\1303913_BA_Basis_update_2\prod_e\ba_basis.k02

2.4.1 Installation precautions

w WARNING!

The S server is installed on the vendor’s premises. Modifications may only be

carried out by Customer Support. The customer may not make any changes to the

server!

The following section is therefore for information purposes only.

Follow the instructions below to ensure safety when positioning the SE server:

● The Server Unit, Management Unit, Application Units and further components are

installed in one or more closed racks. Consequently the ambient operating temperature

inside the rack may be higher than the room temperature. Install the business server in

an environment in which the ambient temperature is always below 35 °C (95 °F).

– Adjust air circulation to prevent the temperature inside the rack from exceeding the

maximum ambient temperature specified for the server components.

– The maximum allowable operating temperature of the server components is 35 °C

(95 °F).

● A certain amount of air flow is required for safe operation of the server components.

– The server components have ventilation openings at the front and rear. Do not

cover or close the ventilation openings. Doing so may cause the server components

to overheat.

● Positioning the Business Server may cause the entire rack to be unstable because of

uneven mechanical loading.

● The racks of the SE server have no stabilizer. When an SU or heavy peripherals are

pulled out of the rack, there may therefore be a risk of it tipping over.

● The power supply for the server components is implemented via power distribution units

mounted in the rack which themselves must be connected to the inhouse power supply

using appropriate CEE connectors.

● The large number of power supply components in the rack means that the configuration

can generate leakage currents > 3.5 mA.

● For this reason the rack may be connected to the in-house power network only via

permanent links or industrial cables in accordance with IEC 60309 (formerly IEC 309) .

v CAUTION!

Equipment damage:

In configurations with multiple feed cables such as the SE server, it must be noted

that all cables must be disconnected to disconnect the system from the power

network.

Fujitsu BS2000 Basic Operating Manual

Other manuals for Fujitsu BS2000