To Next Page

To Previous Page

Switching the server on and off Switching the SE300 on and off

U41858-J-Z126-2-76 73

Dokuschablonen 19x24 Version 7.4us für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010

19. April 2017 Stand 15:41.41 Pfad: P:\FTS-BS\Server\SE-Server\SE-Doku\1303913_BA_Basis_update_2\prod_e\ba_basis.k08

8.1.3 Switching the SE server off

The following hardware components must be switched off in the specified order.

v CAUTION!

This does not disconnect the hardware components completely from the power

source (POWER STAND-BY). To cut the entire system off from the power source,

you must must disconnect the power distribution units from the power source

Notify Customer Support.

1. Switch off the optional Application Units

Before an Application Unit is switched off, the power-on indicator lights up green.

Ê Terminate the customer applications and the operating system properly.

The Application Unit is switched off automatically and enters standby mode.

The status indicator lights up orange. Check this before continuing.

i If the operating system does not automatically switch off the Application Unit,

hold the On/Off switch down for at least four seconds.

Alternatively, as the administrator or AU administrator you can switch the Application

Unit off using the SE Manager (menu Hardware → Units[ → <se server>] (SE<model>),

Units tab, Switch off symbol), see the “Operation and Administration” manual [5].

i The controls, indicators and further on/off options for the AU are described in the

"Additive Components" Operating Manual [4].

Further Application Units are switched off in the same way.

2. Switch off the Server Unit

Ê As the administrator, BS2000 administrator or a privileged operator, switch off the

Server Unit using the SE Manager (menu Hardware →

Units[ → <se server>] (SE<model>), Units tab, Switch off symbol), see the “Operation and

Administration” manual [5].

When the Server Unit is switched off, the BS2000 system is shut down properly taking

into account the remaining runtime specified.

Before the Server Unit is switched off, the power-on indicator lights up green, and after

it has been switched off, it lights up orange. Check this before continuing.

i The controls and indicators of the Server Unit are described in the "Server Unit

x86" Operating Manual [3].

Further Server Units are switched off in the same way.

Fujitsu BS2000 Basic Operating Manual

Other manuals for Fujitsu BS2000