Front of the MU Management Unit
52 U41858-J-Z126-2-76
The DVD-RW drive is used by Customer Support to install and update the M2000 software.
Use of the USB interfaces is reserved for Customer Support.
You can pull the ID card out and push it in again as far as it will go. The ID card contains
various system information, e.g. product name, serial number, MAC addresses and DNS
name.
Controls
ID Identification (ID) button
Lights up (blue) on the front and on the rear of the MU when the ID button is
pressed. The two ID indicators are synchronized.
On/Off button
When the MU is switched off, it is switched on again by pressing the On/Off
button once.
When the MU in is in operation, it is switched off by pressing the On/Off button
once.
V CAUTION!
Possible loss of data!
I The On/Off switch does not disconnect the server from the voltage
grid. To disconnect from the mains completely, remove the power
plugs.
RST or
RESET
Reset button
Pressing the Reset button reboots the MU.
V CAUTION!
Possible loss of data!
NMI NMI button
V CAUTION!
Do not press! Possible loss of data! The NMI button may only be used
by Customer Support.
To Next Page
Loading...
Need help?
General