To Next Page

To Previous Page

Controls Control panel (on the SE700 and SE500)

U41858-J-Z126-2-76 45

Dokuschablonen 19x24 Version 7.4us für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010

12. April 2017 Stand 18:58.59 Pfad: P:\FTS-BS\Server\SE-Server\SE-Doku\1303913_BA_Basis_update_2\prod_e\ba_basis.k05

The control panel contains the following controls and displays (please refer to the numbers

in the figure):

1. UNIT EMERGENCY switch

The UNIT EMERGENCY switch switches the SU /390 off.

2. POWER ON button with lamp

Switches the Server Unit on. When the SU /390 is switched on, POWER ON lights up

green.

3. STAND-BY button

Switches the SU /390 off, but not currentless (power supply units in standby mode).

4. SYSTEM lamp

Displays whether the CPUs of the SU /390 are active.

5. CHECK lamp

Shows whether a fault has occurred.

6. STATUS indicator

Supplies detailed information on the hardware status.

The function of the displays and controls in the operating panel is described in the sections

below.

Fujitsu BS2000 Basic Operating Manual

Other manuals for Fujitsu BS2000