66
Modular RAID Controllers
Modular RAID 6Gb/s (SAS2.0)
Connectors
Indicators
4.5.4 Installation
This section describes how to install the SAS RAID controller in a server.
V CAUTION!
To safeguard against data loss, remember to back up your data before
you change your system configuration.
To install the new controller, proceed as follows:
Connector Type Description
FBU 1-6 Connector to attach FBU
LED Description
L1 (H322) Heart Beat
L2 (H321) Error for Power PC1
L3 (H320) Error for Power PC0
L4 (H102) Power available
L5 (H101) Status
L6 (H100) Cache offload fault
Step 1 Unpack the controller
Unpack the new controller in a static-free environment. Remove it
from the anti-static bag and inspect it for damage.
If the controller appears to be damaged, contact the Fujitsu support
service.
Step 2 Prepare the server
Shut down and power off the server and remove the server blade from
the chassis.
Step 3 Install the new SAS RAID controller
Refer to the server blade specific Options Guide or Upgrade and
Maintenance Manual.
To Next Page
Loading...
Need help?
General
