112
Modular RAID Controllers
Modular RAID 12Gb/s (SAS3.0)
5.6.4 Installation
This section describes how to install the SAS RAID controller in a server.
V CAUTION!
To safeguard against data loss, remember to back up your data before
you change your system configuration.
To install the new controller, proceed as follows:
Step 1 Unpack the controller
Unpack the new controller in a static-free environment. Remove it from
the anti-static bag and inspect it for damage.
If the controller appears to be damaged, contact the Fujitsu support
service.
Step 2 Prepare the server
Turn off the server and remove the cover from the chassis.
Step 3 Install the new SAS RAID controller
Insert the controller in a suitable PCIe slot on the system board. Press
down gently but firmly to ensure the controller is properly seated in the
slot. Secure the controller to the server chassis with the PCI card hold
down latches. Connect the SAS and/or SATA HDDs located in the
system to the SAS cable connector(s) on the controller. Refer to your
server specific Upgrade and Maintenance Manual for information on
the PCIe slot and installing the controller.
To Next Page
Loading...
Need help?
General
