Important notes
Safety notes for the system
This device complies w ith the relevant safety regulations for data processing equipment,
including electronic o ffice machines for use in an office environment. If you have
any questions about whether the device can be used in the intended environment,
please conta ct your sales office or our Service Desk.
• The display surface of the device is sensitive to pressure and scratches. You should therefore
be careful with th e display surface in order to avoid lasting damage (scratche s).
• If the device is brought into the installation site from a cold environment, condensation
can form. Before operating the device, wait until it is absolutely dry and has reached
approximately the same temperature as the installation site.
• When installing and operating the device, please observe the notes on ambient
conditions in "
Technical data", Page 58 and the instructions in "Setting up
an ergonomic video workstation", Page 20.
• To ensure sufficient ventilation, the air inlet and outlet openings of the device m u st be kept clear.
• The device automatically sets itself to the correct voltage within the range from 100 V to 240 V.
Make sure t hat the local mains voltage is neither higher nor lower than this range.
• Ensu re that the power socket on the device and the m ains outlet are freely accessible.
• The ON/ OF F switch does not disconn ect the monitor from the mains voltage. To disconnect
fully fro m the mains supply, disconnect the power plug from the socket.
• The device is equipped with a power cab le that complies with safety standards.
• Use the supplied pow er cable only.
• Lay the cables in such a way that they do not create a hazard (danger of tripping)
and cannot be damaged. When connecting the device, observe the relevant notes
in chapter "
Connecting external devices", Page 25.
• No data transfer cables should be connecte d or disconnected during a thunderstorm.
• Make sure that no objects (e.g. jewellery chains, paper clips, etc.) or liquids get
inside the device (danger of electric shock, short circuit).
• The device is not waterproof! Never immerse the device in water and protect
it from spray water (rain, sea wat er).
• In an emergency (e.g. damaged casing, operation c ontrols or cables, penetration
of liquids or foreign matt er), switch off the device, disconnect the power plug
and contact your sales outlet or our Service Desk.
• Repairs to the device must only be performed by qualified technicians. Unauthorised opening
and incorrect repair may greatly endanger the user (electric shock, fire risk).
• Only use the screen resolution se ttings an d refresh rates specified in Chapter
"
Technical data", Page 58. Otherwise you ma y damage the device. If you are in
any doubt, con tact your sales outlet or our Help Desk.
• Use a screen saver with moving images and activate the power management for
your monitor to prevent still images from "burning in".
• We recommend that you place your device on a durable, non-slip surface. In view
of the many different finishes and varnishes used on furniture, it is possible that the
feet of the device may mark the surface they stand on.
Fujitsu 13
To Next Page
Loading...
