Getting s tarted
Setting up the device
Workstati onErgonomicDevice
When installing your device, please read the recommendations and safety
notes in the "Safety/regulations" manual.
We recommend that yo u place your device on a surface which is not slippery. In
view of the m an y different fin ishes an d varnishes used on furniture, it is possible
that the rubber feet will mark the surface they stand on.
Depending on the location of your device, bothersome vibrations and noises may
occur. To pre vent this, a distance of at least 10 mm / 0.39" shou ld be maintained
from other devices on casing sides without ventilation s urfaces.
In order to avoid overheating, do not cover the ventilation areas
of the monitor or the device.
A minimum distance of 200 mm / 7 .87" from the device must be
observed for ventilation areas.
Do not expo se the device to extreme ambient conditions (see "
Technical data", Page 58 ,
section "Ambient conditions"). Protect the device against dust, humidity and heat.
When the lighting conditions are unfavourable (for instance direct sunlight), reflect ions
may occur which can cause the displayed chara cters to be difficult to read. Suitable
ambient lighting is necessary to avoid these kinds of re flections.
In addition, align your system according to the ambient lighting conditions, for in stan ce
by chang ing the position of the display (horizontal or vertical angle).
Setting up an ergonomic video workstation
1
► Do not position the video workstation
opposite a window (1).
20 Fujitsu
To Next Page
Loading...
