Getting started
Headphone port
Connectingau diodevicesAudioportsConnectingheadph ones
You can connect headphones or external loudspeakers to your system v ia the headphone port.
► Connect the audio cable to the
external device.
► Connect the audio cable to the headphones
port of the system.
The internal loudspeakers are disabled.
If you purcha se a cable from a retailer, please note the following information:
The headphones port on your system is a "3.5 mm jack socket".
If you wa nt to connect headphones or a speaker you will need a "3.5 mm jack plug".
Switchingonforthefirst time: installing the software
Installing,Software,Installing,
Once the installation has been started the device must not be sw itched
off, unless the installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out correctly and the contents
of the hard disk must be completely restored.
If the device is integrated into a network, the user and server details as well as
the network protocol are required during the software installation.
Contact your network administrator if you have any questions about these settings.
When you switch on the device for the first time, the supplied software
is installed and config ured. Plan a reasonable amount of time for this,
as this process must not be interrupted.
You may need the licence number for W indows during the installation. The licence
number is located on a sticker on your device.
Fujitsu 29
To Next Page
Loading...
