Fujitsu ETERNUS DX8700 S3 - Page 1000

Appendix B Factory Default List
B.3 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
1000
■ Modify CA Reset Group
■ QoS
*1: The QoS function is disabled by default and only [Enable QoS] in [Action] is available.
■ Set FC/FCoE Host QoS
■ Set iSCSI Host QoS
■ Set SAS Host QoS
Test Unit Ready Command
Settings
Reservation Conflict Response GOOD (Default)
Sense Settings Notify Change Volume
Mapping
Enable (Default)
Notify Volume Capacity
Expansion
Enable (Default)
Notify Vendor Unique Sense Disable (Default)
Sense Data Conversion No Conversion (Default)
Other Settings Command Monitor Time Default (25 sec.)
Load Balance Response Status CHECK CONDITION / UNIT ATTENTION (Default)
iSCSI Discovery Reply Mode All - Reply All Ports (Default)
iSCSI Reservation Range Storage System (Default)
Screen Setting item Default value
Screen Setting item Default value
Select Ports "Port" checkbox All checkboxes are selected
Screen Setting item Default value
Enable/Disable QoS Operation mode Disable (*1)
Screen Setting item Default value
FC/FCoE Host QoS Setting Bandwidth Limit Unlimited
Screen Setting item Default value
iSCSI Host QoS Setting Bandwidth Limit Unlimited
Screen Setting item Default value
SAS Host QoS Setting Bandwidth Limit Unlimited