Fujitsu ETERNUS DX8700 S3 - Setup SNMP Agent Trap

Chapter 1 System Management
1.8 Network Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
123
7 Click the [OK] button.
 Setting of the SNMP Agent Community starts.
8 Click the [Done] button to return to the [Network] screen.
End of procedure
1.8.8 Setup SNMP Agent Trap
This function notifies events that occur in the ETERNUS DX to the SNMP Manager by an SNMP Trap.
This function configures the trap destination, the trap version, etc.
Up to ten traps can be specified for each ETERNUS DX.
For details on the parameters for this function, refer to "A.1.7.8 Setup SNMP Agent Trap" (page 716)
.
For the factory default settings for this function, refer to "Appendix B Setup SNMP Agent Trap" (page 981)
.
The procedure to set the SNMP Agent trap is as follows:
Procedure
1 Click [Setup SNMP Trap] in [Action].
• If the "SNMP Function" is disabled, the [Setup SNMP Manager] function cannot be used.
• When SNMP Manager exists in a different subnetwork from where the ETERNUS DX belongs, specify the IP
address or the network address of SNMP Manager in the "Allowable IP Address" using the procedure in
"1.8.1 Setup Network Environment" (page 97)
.