Fujitsu ETERNUS DX8700 S3 - Change User Password

Chapter 1 System Management
1.2 Change User Password
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
28
1.2 Change User Password
This function changes the current user's (your) password.
For details on the parameters for this function, refer to "A.1.1 Change User Password" (page 666)
.
The procedure to change the password is as follows:
Procedure
1 Click [Change User Password] in [Action].
2 Specify the parameters.
The main setting items are as follows.
● Password Setting
• Old Password
• New Password
• Confirm New Password
When RADIUS Authentication is used for login, the password cannot be changed.
If an error screen appears under the following conditions, check the parameter settings.
• Each parameter is not entered
• Each parameter fails to satisfy the input conditions
• The old password is different from the current password
• "New Password" does not match "Confirm New Password"