Fujitsu ETERNUS DX8700 S3 - Network Management; A.1.7 Network Management

Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
703
A.1.7 Network Management
A.1.7.1 Setup Network Environment
For details about this function, refer to "1.8.1 Setup Network Environment" (page 97).
For the factory default settings for this function, refer to "Appendix B Setup Network Environment" (page 978)
.
■ When using IPv4
● LAN
• Speed and Duplex
• Wake on LAN
● Interface
• Master IP Address
Description Select the communication speed and mode.
Input condition/
Display contents
• Automatic
• 1 Gbit/s
• 100 Mbit/s Half
• 100 Mbit/s Full
• 10 Mbit/s Half
• 10 Mbit/s Full
Description Select whether to "Enable" or "Disable" the WOL function (*1).
*1: The WOL function starts up the ETERNUS DX, which is connected to LAN, from
another server or a PC via network.
Input condition/
Display contents
• Enable
• Disable
This item is not displayed when an FST port is selected.
Description Input the IP address for the Master CM of the ETERNUS DX.
Input condition/
Display contents
• Numeric characters
• 0 - 255