Fujitsu ETERNUS DX8700 S3 - Modify NAS Interface

Chapter 4 Connectivity Management
4.8 NAS Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
510
The procedure to delete NAS interfaces is as follows:
Procedure
1 Select the NAS interface that is to be deleted (multiple selections can be made) and click
[Delete] in [Action].
 A confirmation screen appears.
2 Click the [OK] button.
 Deletion of NAS interface starts.
3 Click the [Done] button to return to the [NAS Interface] screen.
End of procedure
4.8.6 Modify NAS Interface
This function changes the NAS interface settings.
This function is used in a Unified Storage environment.
For details on the parameters for this function, refer to "A.4.7.4 Modify NAS Interface" (page 892)
.
The procedure to modify the NAS interface settings is as follows:
Procedure
1 Select the NAS interface that is to be changed, and click [Modify] in [Action].
If the NAS interface modification has not been completed successfully, wait for the ETERNUS DX S3 series
status to return to normal and then try again.
To use the Active-Active connection, specify different IP addresses on the same subnetwork for the ports of
each CM that will be duplicated.