Fujitsu ETERNUS DX8700 S3 - Page 511

Chapter 4 Connectivity Management
4.8 NAS Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
511
2 Change the parameters.
The main setting items are as follows.
● NAS Interface Settings
• RIP Setting
• Redundant Port
• IP Address
• Subnet Mask
• Gateway
• IPv6 Link Local Address
• IPv6 Connect IP Address
• IPv6 Gateway
• IPv6 Prefix length
3 Click the [Modify] button.
 A confirmation screen appears.
4 Click the [OK] button.
 Changing of NAS interface settings starts.
5 Click the [Done] button to return to the [NAS Interface] screen.
End of procedure
If an error screen appears under the following conditions, check the parameter settings.
• Each parameter fails to satisfy the input conditions
• The IP address and the network address are the same
• The IP address and the broadcast address are the same
• The gateway is set and the gateway and the network address are the same
• The gateway is set and the gateway and the broadcast address are the same