Fujitsu ETERNUS DX8700 S3 - Page 892

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
892
• IPv6 Connect IP Address
• IPv6 Gateway
• IPv6 Prefix length
A.4.7.4 Modify NAS Interface
For details about this function, refer to "4.8.6 Modify NAS Interface" (page 510).
● NAS Interface Settings
• RIP Setting
Description Input the IPv6 connect IP address of the target port.
Input condition/
Display contents
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation" (page 378)
for details.
Description Input the IPv6 gateway address of the target port.
Input condition/
Display contents
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation" (page 378)
for details.
Description Input the IPv6 prefix length of the target port.
Input condition/
Display contents
3 - 128
Description Select whether to receive the routing information with the target port.
To receive the routing information with the target port, select "Enable". To stop receiving
the routing information, select "Disable".
The RIP is used to share the routing information between routers, and to simplify the
network settings.
Input condition/
Display contents
• Enable
• Disable