Fujitsu ETERNUS DX8700 S3 - Page 973

Appendix B Factory Default List
B.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
973
■ Setup Subsystem Parameters
■ Setup Encryption Mode
■ Setup SMI-S Environment
For the controller firmware version V10L2x or earlier
Screen Setting item Default value
Setup Subsystem Parameters Thin Provisioning Allocation
Mode
TPP balancing
Flexible Write Through
• For the ETERNUS DX200F
- When the ETERNUS DX is shipped from the
factory
Enable
- When the existing controller firmware is
upgraded to V10L30 or later
Disable
• For storage systems other than the ETERNUS
DX200F
Disable
Turbo Mode Disable
Writeback Limit Count 512
Setup Host Load Balance Enable
Reject INQUIRY from
Unauthorized Host
Disable
Optimize for Advanced Format
SSD
• When the ETERNUS DX is shipped from the
factory
Enable
• When the existing controller firmware is
upgraded to V10L30 or later
Disable
Setup Disk Drive
Checkcode Enforcement
Enable
Copybackless Enable
Web GUI Settings Function to Add Host
Use "Add Host Group" Selected
Use "Add Host" Cleared
Screen Setting item Default value
Encryption Mode Setting Encryption Mode Disable
Screen Setting item Default value
Set SMI-S SMI-S
• When the ETERNUS DX is shipped to EMEA
region
Enable
• When the ETERNUS DX is shipped to regions
other than EMEA
Disable