Fujitsu ETERNUS - Required Software and Hardware

Server Connection Guide (iSCSI) for Oracle Solaris
12
Copyright 2010 FUJITSU LIMITED
P3AM-4182-03ENZ0
Chapter 4 Checking the Server Information
The server information registered in the ETERNUS Disk storage system should be checked.
A variety of commands are used to check the following server information.
• iSCSI Software Initiator
Since iSCSI Software Initiator is provided with the OS, installation is not required.
Check the SUNWiscsiu and SUNWiscsir packages using the "pkginfo" command.
• iSCSI Initiator name
Execute the following command:
The iSCSI Initiator name is displayed in the "Initiator node name" column.
• Server-side LAN card IP address for connecting to the ETERNUS Disk storage system
Execute the following command:
Set this IP address if it is not already set.
• Initiator CHAP Name
The Initiator CHAP Name is the user name for unidirectional CHAP authentication, and is not
required if CHAP authentication is not used.
Execute the following command:
The Initiator CHAP Name is displayed in the "CHAP Name" column of the applicable target
information.
# iscsiadm list initiator-node
# ifconfig -a
# iscsiadm list initiator-node