Server Connection Guide (iSCSI) for Oracle Solaris
23
Copyright 2010 FUJITSU LIMITED
P3AM-4182-03ENZ0
Chapter 8 Checking Connections
8.1 Turning on the Devices
To turn on the connected devices, use the following procedures:
Procedure
1 Turn on any devices (such as LAN switches) on the LAN path between the
ETERNUS Disk storage system and server.
2 After checking that the Ready (or equivalent) LED of the LAN switch is lit, turn on
the ETERNUS Disk storage systems.
3 After checking that the ETERNUS Disk storage systems' Ready LED is lit, turn
on the server.
End of procedure
8.2 Logical Unit Recognition
Check the state of the ETERNUS Disk storage system LUNs (logical units) using the "format"
command.
Example: ETERNUS2000
# format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
1. c6t25d0 <FUJITSU-E2000-0000 cyl 510 alt 2 hd 64 sec 256>
/iscsi/disk@0000iqn.2000-09.com.fujitsu%3Astorage-system.e2000%3A00001001-cm00002,0
2. c6t26d0 <FUJITSU-E2000-0000 cyl 510 alt 2 hd 64 sec 256>
/iscsi/disk@0000iqn.2000-09.com.fujitsu%3Astorage-system.e2000%3A00001001-cm00002,1
3. c6t27d0 <FUJITSU-E2000-0000 cyl 510 alt 2 hd 64 sec 256>
/iscsi/disk@0000iqn.2000-09.com.fujitsu%3Astorage-system.e2000%3A00001001-cm10004,0
4. c6t28d0 <FUJITSU-E2000-0000 cyl 510 alt 2 hd 64 sec 256>
/iscsi/disk@0000iqn.2000-09.com.fujitsu%3Astorage-system.e2000%3A00001001-cm10004,1
Specify disk (enter its number): Specify disk (enter its number):
Indicates connection
via "CM0"
Indicates connection
via "CM1"
To Next Page
Loading...
Need help?
General
