Fujitsu fi-5220C

2.2LoadingDocumentsontheADFforScanning(2)
● Place one card at a time into the Auto Document Feeder.
● ID card feeding requires the card to be fed through the Auto Document Feeder in
portrait mode as in the following figure.
● Smooth cards should be placed face down in the Auto Document Feeder.
● Embossed cards (raised lettering) should be placed with the embossed side down.
● The card to be scanned should be within the ISO7810 compliance, type ID-1.
ISO7810-compliant, Type ID-1 card
Material: PVC (Poly vinyl chloride) or PVCA (Polyvinyl chloride acetate)
Dimensions: 3.4 inch (height) x 2.1 inch (width) / 86 mm x 54 mm
Thickness:
0.03 ± 0.003inch / 0.76 ± 0.08mm
● Cards that are excessively rigid or less flexible may not feed smoothly and excessive
noise may occur.
● Cards should be clean from oil and without labels.
● Cards cannot be scanned when the imprinter is installed.
1
2
3 4
AllRightsReservedCopyright2006©PFULIMITED
file://///Hd-htgle21/Manual/fi-5120C5220C-lynx2/OG/R03/contents/EN/02/c020202.htm(2/2)2006/08/2915:59:53