CONTENTS
Introduction
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATION
2.1 Turning the scanner ON/OFF
2.2 Setting the ADF
2.3 Loading documents onto the ADF
2.4 Scanning document using the Flatbed
2.5 Scanning documents
2.6 How to use the Scanner Driver
3 SCANNING VARIOUS TYPES OF DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 ONLINE SETUP
8 DOCUMENT SPECIFICATION OF ADF
9 OPTIONS
10 SCANNER SPECIFICATIONS
Appendix
2.3 Loading documents onto the ADF (Continued from the previous page)
4. Adjust the side guides to the width of the documents.
Move the side guides so that they contact both sides of the documents. If there is any space between the side guides and the edges
of documents, the scanned image may be skewed.
Set the documents face-down onto the ADF paper chute (so that the side to be scanned faces towards the ADF paper chute).
(1) Document, (2) Side Guide, (3) Side Guide button (both sides)
ATTENTION
● Please remove clips and staples from the document. When double-feeds or miss picking occurred, reduce the quantity of document.
● When loading small documents onto the ADF paper chute, be careful not to touch the Chute roller cover for it may open while scanning
operation and your fingers may get caught.
1 | 2 | 3 | 4 | 5 | 6
All Rights Reserved, Copyright (C) PFU LIMITED 2003
To Next Page
Loading...
Need help?
General