Fujitsu fi-5950 - Password Setting; Setting a Password

175
8.1 Scanner Settings
8
SCANNER SETTINGS
■ Password Setting
By setting a password, the Software Operation Panel can run in [View Only mode] which allows users to
only view the scanner settings.
The scanner settings can be configured if no password is set.
In order to prevent unnecessary changes to the settings, a password can be used to restrict user operations.
Setting a Password
Set a password in the following procedure.
1. Right-click the Software Operation Panel icon in the taskbar, and select
[Password Setting] from the menu.
⇒ The [Password setting] dialog box appears.
2. Enter a password then again to confirm, and click the [OK] button.
Up to 32 characters can be used for the password.
Note that only alphanumeric characters (a to z, A to Z, 0 to 9) are allowed.
⇒ A message dialog box appears.
3. Click the [OK] button.
⇒ The password is set.
ATTENTION
1.The user must configure password settings and perform initialization.
2.Keep the password you set written down in order not to forget it.