Fujitsu fi-5950 - Imprinter Selection

216
8.24 Imprinter Selection
8.24 Imprinter Selection
You can specify which imprinter to use; Pre-imprinter or Post-imprinter, if you already have installed these
options.
Configure the settings for the Imprinter Selection as follows:
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 173.
2. Select [Device Setting 2] from left side list in the window, and select
[Imprinter selection] from its lower level.
3. Select the Imprinter to use.
Normal (obey Host specification) : Complies with the scanner driver setting.
Forcibly select Pre-imprinter : Pre-imprinter is forcibly used to print unless directed by
the scanner driver.
Forcibly select Post-imprinter : Post-imprinter is forcibly used to print unless directed by
the scanner driver.
HINT
For details on the specifications of the imprinter, refer to “9 OPTIONS” on
page 223.