215
8.23 Jam Detection Outside of Scannable Area When Transporting paper
8
SCANNER SETTINGS
8.23 Jam Detection Outside of Scannable
Area When Transporting paper
If this function is turned On, such a case, in which the documents are fed outside of the scannable area due
to over-skew, is judged as a jam. You can turn it On and Off.
Configure the settings for the Jam detection outside of scannable area when transporting paper as follows:
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 173.
2. Select [Device Setting 2] from left side list in the window, and select [Jam
detection outside of scannable area when transporting paper] from its
lower level.
3. Select “Enable” to judge such a scan as a jam, and select “Disable” not to
judge it as a jam.
To Next Page
Loading...
