214
8.22 Alarm Setting
8.22 Alarm Setting
You can make the alarm to sound beeps when a jam or multifeed occurs, as well as disabling the alarm.
Configure the settings for the Alarm setting as follows:
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 173.
2. Select [Device Setting 2] from left side list in the window, and select
[Alarm setting] from its lower level.
3. Select “Enable alarm” to sound beeps when a jam or multifeed occurs.
Select “Disable alarm” to disable the alarm.
To Next Page
Loading...
