195
8.5 Multifeed detection when scanning in manual feed mode
8
SCANNER SETTINGS
8.5 Multifeed detection when scanning
in manual feed mode
Set whether to detect multifeed during manual feed mode or not.
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 173.
2. Select [Device Setting 2] from left side list in the window, and select
[Multifeed detection when scanning in manual feeding mode] from its
lower level.
3. Select one of the following option.
Disable : Does not detect multifeed at manual feed mode.
Follow driver settings : Multifeed detection is valid only when device driver allows multi-
feed detection.
To Next Page
Loading...
