24
2.7 Setting up the Stacker
■ Changing Stacker inclination/motion
The location of the stacker can be switched when ejecting documents by fixing the stacker height in the
appropriate position, or by using either the horizontal setting for bottom edge alignment or the tilting for-
ward setting for leading edge alignment. The factory default is set to the horizontal setting. When using the
tilting forward setting for leading edge alignment, follow the procedure below to switch the position of the
stacker.
<Switching to the tilting forward setting>
1. Slide the stacker out towards you.
2. Push down the part of the stacker which is closer to you.
⇒ The stacker inclines towards you.
Bottom edge alignment by
horizontal stacker setting
Leading edge alignment by tilting
forward setting of stacker
To Next Page
Loading...
