36 U41578-J-Z875-1-76
Configuring the RAID system
Deleting old configuration data
Select the Controller Actions file card. The display shown below will appear. If
you wish to delete old or invalid configuration data, click the Clear Configuration
button.
Before you set a new RAID configuration, you must delete the old configuration.
WARNING: This operation cannot be undone. Selecting the Clear Configuration
button will permanently delete all current configuration data and any linked user
data. You can use this function to deliberately delete old configurations and also
to normalise the system when restarting after a fault (i.e. when various red
LEDs are lit).
A prompt will be displayed warning you that you are about to permanently
delete data. If you still wish to proceed, click OK.
To Next Page
Loading...
