U41578-J-Z875-1-76 79
FibreCAT S80 Quick Installation Guide Installation for PRIMERGY
Installation for PRIMERGY
Documentation / Management Tool / Settings can be retrieved from:
- Internet ftp site ftp://raid@ftp.fujitsu-siemens.com/
(user: raid, Pass word: 4jumbo17)
Please be sure to have the following Microsoft Internet Explorer settings
activated:
IE: Tools => Internet options => Advanced => x Enable folder view for ftp sites
Mandatory FibreCAT S80 FFx2 Firmware is 8.57. The needed Graphic User
Interface Management tool is Mylex GAM/SAM or Spheras 1.3 How to install
Spheras can be found at ftp: FibreCAT_S80/Manuals/Spheras-Manual_e.pdf
Installation procedure
HBA installation
● Shut off Primergy. Insert Host Bus Adapter (HBA) into the Primergy
● Power on the FibreCAT S80, but do NOT connect the S80 to the HBA
● Power on the Primergy You will see the ”New Hardware found” screen.
● Insert the ServerView CD, wait, cancel the Server View installation itself
Continue until ”search for suitable driver” is displayed.
● Select ”Arbitrated loop Automap” type.
WAIT! DO not even move the MOUSE !!! IGNORE ”insufficient screen
buildings”!! WAIT for finish!!
● Power down the Primergy.
● Connect the Primergy and the (ready) FibreCAT S80
● Restart the Primergy
Installing Emulex / QLogic configuration tools
Insert ServerStart CD
Go to \programs\general\EMULEX\
start ”setupapps.exe”. This will install ”elxcfg.exe” (resp. lputil.exe, depend-
To Next Page
Loading...
