80 U41578-J-Z875-1-76
Installation for PRIMERGY FibreCAT S80 Quick Installation Guide
ing on driver) and ”HBAnyware”. For BX600, which uses an QLogic
adapter: go to \programs\general\QLogic\ install SANSurfer.exe, which
gives you the configuration software ”SANblade Manager”. Using the tools
check HBA FW, Settings, check WWNN name of the FibreCAT S80 (21…)
Installing GAM SAM
Attention: If this GUI is preferred, do not install both, GAM SAM and
Spheras!
Run only one set of Agents on one node only, even you have more than
one host!
● Insert Server Stop CD for GAM SAM installation
– Cancel FSC server Start Installation as an application
– Start MS Explorer, go to CD directory
\programs\general\MYLEX\GAM_FW7\Windows
– Start setup.exe
– Select Components: SAN Array Manager Client and Global Array
Manager Server
– Install GAM / SAM, following the instructions
– establish a user under “Manage / local user & groups / new user” .
New user: gamroot Password (example): gamroot check checkbox “PW
never expires”
● Start Mylex GAM SAM, Server Groups and the Mylex DAC FFx2 controller
are now discovered.
Installing Spheras (if this GUI is preferred)
Run only one set of Agents on one node only, even you have more than
one host!
– download the Management tool from the ftp site, install it following the
instructions if the FibreCAT S80 is not found, reset HBA using
HBAnyware, restart Agents
– Be sure to set the FC speed to 2 Gbit/s fix, not Auto negotiation
● Configure Disk groups and LUNs
To Next Page
Loading...
