40 U41578-J-Z875-1-76
RAID wizard
It is advisable to assign the disk drives following a given logical sequence (e.g.
c0, c1, c0 and so on). The reasons for this are the same as those given earlier
in this manual for adopting loop connections in cable management. Assigning
disks in a given logical order also makes sense performance wise.
When you select a drive in the Available Drives window and then click the Add
button, the drive entry will disappear from the Available Drives window and
appear in the Member of Disk Group window.
This example shows a fully configured disk group. The total capacity of all the
drives in the current disk group (disk array / disk pack) is shown on the right-
hand side.
To Next Page
Loading...
