6 - Deutsch Wichtige Hinwei se
FCC Compliance Statement
If th e device complies with the FCC regulations, the FCC s ign can be foun d on the type rating plate.
FCC Class B Compliance State
ment
The following statement applies to the pro duct s covered in this manual, unless otherwise specified
herein. The statement for other products will a ppear in the accompanying documenta tion.
NOTE:
This equipment has been tested and found to com ply with the limits for a "Class B" digital
device, pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian
Interference-Causing E quipment Standard ICE S-003 for digital apparatus. T hese limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate r adio frequency ene rgy and, if not installed
and used in strict accorda nce with the instructions, m ay cause harmful interference to radio
communications. However, there is no gu arantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by o ne or more of the following measures:
• Reorient or relocate the receiving antenn a.
• Increase the sep
aration between equipment and the receiver.
• Connect the equipment into an outlet on a c ircuit different from that to
which the receiver is connected.
• Consult the de
aler or an expe rienced radio/TV technician for help.
Fujitsu Technology Solutions GmbH is not responsible for any radio or television interference
caused by unauthorized modifications of this equipment or the substitution or a ttachment
of connecting cables and equipment other than those specified by Fujitsu Technology
Solutions GmbH. The correction of interferences caused by such unauthorized modification,
substitution or a ttach ment will be the responsibility of the user.
The use of shielded I/O cables is required when connectin g this equ ipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC and ICES rules.
CE-Kennzeichnung
Dieses Gerät erfüllt in der au sge lieferten Ausführung die Anforderungen
der EG-Richtlinien 2004/108/EG "Elektroma gnetische Verträglichkeit" und
2006/95/EG "Niederspannungsrichtlinie".
8 Fujitsu Technology Solutions
To Next Page
Loading...
