Important notes English - 5
Transporting the device
Device,Trans portati onRetransportation
Transport a ll parts separa tely in their original packaging or in a packaging which
protects them from knocks and jolts, to the ne w site.
Do not unpack them until all transportation ma noeuvres are completed.
If the device is brought from a cold environment into the room whe re it will be used,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
Cleaning the d evice
Device,Trans portati onRetransportationSystemu nit,seeD evic
e
Tu rn off all power and equipment sw itches and disconne ct the power
plug from the m ains outle t.
Do not cle an any interior parts yourself, leave this job to a service technician.
Do not use any cleaning agents that c ontain abrasives or may corrode
plastic ( alcohol, thinner or acetone).
Never clean the device with water! Water entering into the device could
present a serious risk to users (e.g. electric shock).
Ensure that no liquid ent ers the system.
Thesurfacecanbe
cleaned with a dry cloth. If particularly dirty, use a cloth that has been
moistened in mil
d domestic detergent and then carefully wrung out.
Use disinfecta
nt wipes to clean the keyboard and the mouse.
Energy saving, disposal and recycling
DisposalEnergysavingRecyclingDrivers&UtilitiesDVDUserDocumentationDVD
Further information can be found on the "Drivers & Utilities" DVD.
Fujitsu Technology Solutions 41
To Next Page
Loading...
