T r oubleshooting
LifeBook E Series from Fujitsu
93
Notebook fails to recognize DVD/CD-ROM. 4. DVD/CD-ROM tray is not latched shut. 4. Push on the front of the DVD/CD-ROM
(continued) tray until it latches.
5. Setup utility is set to something other than 5. Revise BIOS settings to set the Secondary
DVD/
CD-ROM or Auto for the Secondary
Master correctly. (See Main menu and
Master Controller
. Primary Master submenu. See BIOS guide
on page 63 for more information.)
6. Wrong drive designator was used for 6. Verify the drive designator used by the
DVD/CD-ROM in the application. application is the same as the one used by
the operating
system. When the operating
system is booted
from a DVD/CD-ROM dri-
ve designations are auto
matically adjusted.
7. Windows
DVD/
CD auto insertion function
7. Start the DVD/CD from the desktop or
is disabled. application software or re-enable the
WindowsDVD/CD auto insertion function.
(See DVD/CD-ROM Access Indicator on
pages 24 and 26 for more information.)
8. DVD/CD is dirty or defective. 8. Wipe DVD/CD with a non-abrasive CD
cleaning cloth and reinset. It if still will
not work try another DVD/CD in the drive.
The DVD/CD-ROM Access indicator on the 1. The Windows DVD/CD auto insertion 1. This is normal. You can disable this function
Status Indicator panel blinks at regular intervals function is active and is checking to see if you wish. (See DVD/CD-ROM Access
when no DVD/CD is in the tray or the if a DVD/CD is ready to run. Indicator on pages 24 and 26 for
DVD/CD-ROM drive is not installed. more information.)
Problem Possible Cause Possible Solution
Five
To Next Page
Loading...
