Section Five
98
Problem Possible Cause Possible Solution
You have installed a parallel-port device, 6. Parallel-port is set to output only. 6. Check parallel port setting in the BIOS and
a serial-port device or a USB device. set to Bi-directional or ECP.
Your notebook does not recognize the
device, or the device does not seem to
work properly. (continued)
PC Card Problems
A card inserted in the PC Card slot 1. The card is not properly installed. 1. Remove and re-install the card.
does not work or is locking up the system. (See PC Cards on pages 76-77.)
2. The card may have been installed with an 2. Close your application and
application running and your notebook restart your notebook.
doesn’t know it’s there.
3. Your software may not have the correct 3. See your software documentation
software driver active. and activate the correct driver.
4. You may have the wrong I/O address 4. See your PC Card documentation to
selected for your PC Card device. determine the required I/O address.
5. Your PC Card device and another device are 5. Check all I/O addresses in the BIOS setup
assigned the same I/O address. utility and your other installed hardware
and make sure there are no duplications.
To Next Page
Loading...
