Three
Using Your LifeBook E Series
LifeBook E Series from Fujitsu
27
8. Double click on the DVD/CD-ROM drive
manufacturer’s name and model.
9. The DVD/CD-ROM drive manufacturer’s
name and model properties dialogue box
will be displayed.
10. Click on the Settings tab.
11. Click on the automatic insertion
notification box to toggle it off.
12. Click on OK.
13. Click on Close in the system properties
dialogue box.
14. Click on Yes in the system settings,
change pop-up to restart your notebook
and activate this change.
You can re-enable the function by repeating the
process except that step 11 will change the setting
to on.
Hard Drive Access or Removable
Media Drive Access Indicator
The Hard Drive Access indicator tells you when
either the internal hard drive, an optional
second hard drive or an optional Zip drive
is being accessed.
POINT
The Hard Drive Access indicator does
not show which hard drive or Zip drive,
is being accessed. It works the same for
any one.
PC Card Access Indicators
The PC Card Access indicators tell you when
your notebook is accessing a PC card. Card 1
is the bottom connector inside the slot and
Card 2 is the upper connector inside the card
slot. Type III cards are always Card 1 only.
The PC Card Access indicator will flash if
your software tries to access a PC Card even
if none are installed.
NumLk Indicator
The NumLk indicator tells you the internal key-
board is set in ten-key numeric keypad mode.
(See page 32 for more information on the numeric
keypad.) You can activate the NumLk mode by
pressing the NumLk/ScrLk key while holding
down the Shift key. Deactivate the setting the
same way that you activated it.
Floppy Disk Drive Access Indicator
The Floppy Disk Drive Access indicator tells you
when a floppy disk drive or SuperDisk drive is
being accessed. The Floppy Disk Drive Access
indicator will flash when your software tries to
access a floppy disk or SuperDisk even if no
floppy disk drive or SuperDisk drive is installed.
To Next Page
Loading...
